Power stations
Bluetti Elite 100 V2 vs Jackery Explorer 1000 v2 (2026): which should you buy?
By Mike · Updated October 8, 2026 · Based on manufacturer specs and the Amazon listings
These two hold about the same energy. The Jackery has 46Wh more, but Bluetti lists a lower standby draw, so on paper the Bluetti runs longer on small loads. The Bluetti also has more output, more outlets and up to 2.5 times the solar input (in Turbo mode). The Jackery is lighter, and quieter on paper.
Choose the Bluetti Elite 100 V2 if
- You want the most runtime on small loads, on paper. Bluetti lists about 10W of standby draw against Jackery's 18W, so the Bluetti runs a router about 31 hours against about 25. That lead rests on Bluetti's own standby figure.
- You'll run things between 1,500W and 1,800W, like a bigger microwave or a hair dryer on high. The Jackery tops out at 1,500W.
- You recharge from solar. It takes up to 1,000W of panels in Turbo mode (600W otherwise). The Jackery takes 400W.
- You want a fast switchover for a router, modem or laptop. Bluetti lists 10ms or less and Jackery within 20ms. Neither is zero-break, and Jackery warns against workstations and servers.
- It'll sit somewhere cold. Bluetti rates discharge down to -4°F. Jackery's limit is 14°F.
Choose the Jackery Explorer 1000 v2 if
- Every pound counts. It's about 23.8 pounds, 1.5 pounds lighter.
- It will sit next to your bed. Jackery lists its fan at 22dB or less. Bluetti says 30dB under 600W and up to 50dB at max. Those are makers' claims, not our test.
- You want a quick charge in the default mode. Jackery lists about 1.7 hours. The Bluetti's default Standard mode lists about 2 hours.
The two units
Bluetti Elite 100 V2
1,024Wh and 1,800W in about 25 pounds. Bluetti publishes a low standby draw (about 10W), and it has no expansion port.
Jackery Explorer 1000 v2
1,070Wh and 1,500W in about 23.8 pounds. It's the lightest of the 1kWh units we compare, and Jackery says it doesn't support add-on battery packs.
As an Amazon Associate I earn from qualifying purchases.
Key specs
| Bluetti Elite 100 V2 | Jackery Explorer 1000 v2 | |
|---|---|---|
| Capacity | 1,024Wh | 1,070Wh |
| Rated AC output | 1,800W | 1,500W |
| Weight | About 25.3 lb | About 23.8 lb |
| Wh per pound | About 40 | About 45 |
| Wall charge to full | About 2 hr in Standard mode (600W) | About 1.7 hr (default mode) |
| Max solar input | 1,000W in Turbo mode; 600W in Standard and Silent modes | 400W |
| Expandable | No (no expansion port listed) | No |
| Warranty | 5 years (Amazon listing) | 3 years, extendable by 2 (5 max) |
Full specs
| Bluetti Elite 100 V2 | Jackery Explorer 1000 v2 | |
|---|---|---|
| Surge / boost | 2,700W "Power Lifting Mode" (heating devices only) | 3,000W |
| Battery | LiFePO4 | LiFePO4 |
| Rated cycle life | 4,000+ cycles to 80% | 4,000 cycles to 70% |
| Dimensions | 12.6 x 8.5 x 9.8 in | 12.87 x 8.82 x 9.72 in |
| AC outlets | 4 | 3 |
| USB-C | 1 x 140W, 1 x 100W | 1 x 100W, 1 x 30W |
| USB-A | 2 x 15W | 1 x 18W |
| Other ports | 12V car port (10A), 2 x DC5521 (5A each; they share the car port's 10A) | 12V car port (10A) |
| Wall charge to 80% | 45 min in Turbo mode (1,200W, set on the unit's display) | Not stated |
| Solar voltage range | 12 to 60V, 20A max | 16 to 60V (two ports, 200W each) |
| Car charging | Yes, 12/24V (car cable not in the box); Bluetti says full in about 1.8 hr with its Charger 1 | Yes (about 12 hr; about 3 hr with Jackery's car fast charger) |
| UPS switchover | 10ms or less | Within 20ms (Jackery's claim; not zero-break) |
| Pass-through charging | Yes | Yes (AC output limited to 1,500W while charging) |
| Standby draw (maker's figure) | About 10W | 18W |
| Fan noise (maker's claim) | 30dB under 600W (product page); 50dB max (manual) | 22dB or less (help center, no test conditions) |
| App | Yes (Wi-Fi and Bluetooth) | Yes (Wi-Fi/Bluetooth) |
| Discharge temperature | -4 to 104°F | 14 to 113°F |
| Charge temperature | 32 to 104°F | 32 to 113°F |
Where the sources disagree:
- Bluetti Elite 100 V2: Surge: the Amazon listing's detail fields say "3600W Surge Power". Bluetti's page and manual only give 2,700W Power Lifting Mode, for resistive loads rated 1,800 to 2,700W, and say actual output stays 1,800W. The page doesn't use 3,600W.
- Bluetti Elite 100 V2: Noise: the product page says 30dB under 600W. The manual's spec table says 50dB max.
- Bluetti Elite 100 V2: Weight: the manual says 25.3 lb; the product page and Amazon listing say 25 lb.
- Bluetti Elite 100 V2: Solar: the 1,000W solar figure is for Turbo mode. In Standard and Silent mode the manual caps solar at 600W.
- Jackery Explorer 1000 v2: Fast charge: the Amazon listing says 0 to 100% in 1 hour "with emergency charging activated via the Jackery App". Jackery's help center says emergency charging mode can't be set in the app and lists AC charging as about 1.7 hr. The page uses 1.7 hr.
- Jackery Explorer 1000 v2: Noise: the help center lists the fan at 22dB or less. The Amazon listing describes a 30dB quiet overnight charging mode. Neither gives test conditions.
- Jackery Explorer 1000 v2: Solar: the Amazon listing says it is compatible only with Jackery solar panels. The help center gives a 16 to 60V input spec without that limit.
- Jackery Explorer 1000 v2: Warranty: the help center says 3 years, extendable by 2. The Amazon listing's warranty field just says "1". The page uses the help center.
Specs are from Bluetti's product page and user manual, Jackery's help center and product page, and the two Amazon listings, checked October 8, 2026.
What they will run (estimates)
Hours = capacity x 0.85 x 0.90 ÷ (load + standby draw). The 0.85 covers inverter losses. The 0.90 assumes 90% of the battery is usable. That's the figure Bluetti publishes, and we apply it to every unit because the other makers publish none. Standby draw is each maker's own figure. These are estimates, not tests.
| Load (typical draw) | Elite 100 V2, 1,024Wh | Jackery, 1,070Wh |
|---|---|---|
| Phone charges (about 15Wh each, via USB) | About 52 charges | About 55 charges |
| Wi-Fi router (15W) | About 31 hr | About 25 hr |
| CPAP, no heated humidifier (40W) | About 16 hr | About 14 hr |
| Mini fridge (45W average), rough estimate | About 14 hr | About 13 hr |
| Laptop (60W) | About 11 hr | About 10 hr |
| 50-inch TV (100W) | About 7.1 hr | About 6.9 hr |
| Full-size fridge (120W average), rough estimate | About 6.0 hr | About 5.9 hr |
| Microwave (1,000W) | About 0.8 hr | About 0.8 hr |
| Space heater (1,500W) | About 0.5 hr | About 0.5 hr, at its rated limit |
The fridge rows are rough because compressors cycle on and off and pull a surge at startup. The phone row runs off the USB ports, so standby draw doesn't apply.
One night of outage: a full-size fridge plus a CPAP draws about 160W together. The Bluetti Elite 100 V2 runs that pair for about 4.6 hours, and the Jackery Explorer 1000 v2 about 4.6 hours. Neither gets through an 8-hour night, so you'd be choosing between the fridge and the CPAP before morning.
Skip it if
Skip the Elite 100 V2 if quiet is the top priority, or if you expected the full 1,000W solar input all the time. It only takes 1,000W in Turbo mode.
Skip the Jackery if you need to run anything over 1,500W, or if you plan to recharge from more than 400W of solar.
Questions about this pair
Which one keeps a CPAP going longer?
The Bluetti, by about an hour and a half on paper: about 16 hours against about 14 at 40W with no heated humidifier. The Bluetti has less capacity but a lower standby draw, which matters more at small loads.
Is the Bluetti's 45-minute charge real?
It's Bluetti's figure for 0 to 80% in Turbo mode at 1,200W. The manual says you set Turbo on the unit's display. In the default Standard mode (600W), Bluetti lists about 2 hours to full. Jackery lists about 1.7 hours in its default mode.
Is the Jackery's 1-hour charge real?
We can't confirm it. The Amazon listing says it needs emergency charging turned on in the Jackery app, but Jackery's help center says emergency charging can't be set in the app. We use Jackery's 1.7-hour figure.
Can I add a battery to either one later?
No. Jackery says the Explorer 1000 v2 doesn't support battery packs, and the Elite 100 V2 has no expansion port in its manual.
Related comparisons
- Bluetti AC180 vs Jackery Explorer 1000 v2
- Bluetti Elite 100 V2 vs EcoFlow DELTA 3
- EcoFlow DELTA 3 vs Jackery Explorer 1000 v2
By Mike · Last checked October 8, 2026 · Based on manufacturer specs and the Amazon listings.